The temperature probe bolts on to the back corner of the heater bed through the little hole. If you bought an external temperature probe, connect it to the white socket on the underside of the CPU (do before atatching). Open the back of your UP3d, remove the old CPU and insert the replacement. Step 1īuy a GCODE CPU for Tiertime UP! plus mini cetus 3D printer smoothieware from tinyfab.xyz on ebay Step 2 The instructions for setting up this new CPU took me about a day to figure out so hopefully these might be useful to someone. This is a lot of hassle and I was in the process of dumping my old UP when I saw a GCODE CPU on ebay for $90 - I bought it and it works great, now I have a fully open source 3d printer I can use with any slicer or filament and which works great with Octoprint. Some enterprising folks have got around these restrictions by putting resisters in series with the thermistor or by transcoding GCODE into UP3D code. The UP hot-end is better then I ever realised when I bought the printer - it's all-metal and heats up to 300C which is enough to work PETG and most of the exotic filaments that are now available. Only get a choice of 2 temperatures - PLA or ABS and these are the wrong temperatures for most non-UP brand filament.Impossible to turn the support generation off.Have to plug the printer into a PC USB socket.The stock UP3D mini firmware is pretty good - UP software gives you a slicer and a GUI all in one program.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |